Cradlepoint CBA750B Manual do Utilizador Página 5

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 18
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 4
LPE, LE products. If the APN was manually entered via the router’s GUI, modems would
connect on LTE but some would not connect on eHRPD (3G). Patched issue to allow
eHRPD connections.
LPE products. Repaired mismatched carrier SIM issue when modem is switched from one
carrier firmware load to another
Known issues:
IPSec. Certificates do not work if Router Services used (new feature in 5.2.0)
IPSec. IKE Phase 2 SHA2-256 Hash is incompatible with the latest Cisco and Juniper
firmware releases. CradlePoint routers are still compatible with each other.
If any of the routers WAN connections (Ethernet, Wi-Fi as WAN, modem) connects to a
device that has the same IP subnet as the router, the router will disable the interface and
provide a Bounce Page warning that the WAN interface has a conflict. Simply change the
LAN IP Address on the Network Settings -> WiFi / Local Network Settings page in the UI.
Wi-Fi as WAN
The router will not connect to a host router that is in WPA-Enterprise mode.
You cannot connect to another router using WPS. The WPS setting in the router works for
a client attached to it, not for it to attach to a host router.
Wi-Fi
If WEP or TKIP encryption is used, the router will not broadcast above 54Mbps. This is a
WiFi Alliance logo certification requirement for new devices. WEP and TKIP have both
been deprecated by the WiFi Alliance and WPA2/AES is the default router encryption.
Carrier
AT&T. These modems appear to block some incoming ports. That affects the ability to use
features such as Remote Management.
LTE
Unless you have a specific service from your carrier, LTE modems will not generally provide
an externally-available IP address. Services, such as Remote Management, will not work.
Modem
Franklin U301. The modem works well in the router as the primary WAN interface. But if it
is used in failover mode with an Ethernet connection, the modem may not be able to
connect when the Ethernet connection is removed.
Franklin S600C. This modem’s firmware version or signal strength information may not be
correct.
Franklin U770. The Modem’s Ethernet address conflicts with the default address of the
Guest LAN. A warning message is placed in the log and the Guest LAN is disabled. If you
Vista de página 4
1 2 3 4 5 6 7 8 9 10 ... 17 18

Comentários a estes Manuais

Sem comentários